Does anyone know the size....


7 replies to this topic
  • odonnks

Posted March 20, 2006 - 04:48 PM

#1

Does anyone know the size of the nut that holds the front drive sprocket on?
I'm planning to replace the stock 14 T and know I don't have a metric socket that large. :thumbsup:

Thanks

  • holyroller1

Posted March 20, 2006 - 04:57 PM

#2

My 06 is 27mm

  • odonnks

Posted March 20, 2006 - 05:45 PM

#3

Thank you !

  • odonnks

Posted March 21, 2006 - 06:36 AM

#4

Does removal of the sprocket require a puller or will it come off fairly easy once the nut is removed?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • hankdog

Posted March 21, 2006 - 07:42 AM

#5

Does removal of the sprocket require a puller or will it come off fairly easy once the nut is removed?


No puller required, it's a standard splined sprocket. Nut is torqued to 54 ft lb. Nut is 27mm, same size as rear axle.

  • odonnks

Posted March 21, 2006 - 08:21 AM

#6

Thanks !

  • Kepy

Posted March 21, 2006 - 12:48 PM

#7

Does anyone know the size of the nut that holds the front drive sprocket on?
I'm planning to replace the stock 14 T and know I don't have a metric socket that large. :thumbsup:

Thanks


The nut is very tight (about 30Nm), so you'll need a fellow sitting on your bike and pulling both brakes otherwise the rear wheel will just slide over the floor :thumbsup:

  • byggd

Posted March 21, 2006 - 02:24 PM

#8

Naaaa just whip out your trusty CP734 air gun :thumbsup:




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.