neutral light indicator

1 reply to this topic
  • nimiz1

Posted March 09, 2006 - 09:32 AM


is there any way to put a neutral light indicator on the older wr/yz-400 1998/1999 thet have no bettery.
i just put the rekluse and it is herd to find the nutral.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted March 09, 2006 - 10:27 AM


You could. It would involve bringing a electrical source to a lamp (an LED is the best choice) and then from the lamp to ground via the blue wire to the neutral switch. However, I would either separate the entire circuit from the CDI by placing a diode in the line running from the lamp/blue wire junction back to the CDI, or just disconnect the CDI from the neutral switch.

That being said, having a lamp to tell you that you missed neutral is not going to make it very much easier to find. It sounds like your set up needs a little trimming.

Related Content


Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

100 hrs on 2014 yz450f, shim valves or replace them? by ttr230rider6

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  79 replies

Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies

Michigan Motocross Tires by 288yz450

Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.