Spark Plug Boot


2 replies to this topic
  • hondajohn

Posted March 04, 2006 - 06:37 PM

#1

My Spark plug boot on my 93 XR600R came off in my hand today and will not resecure to the spark plug wire. Anyone have any ideas on how I should fix this it looks like it is worn out so I would like to replace the wire boot and all. Where should I start looking for a new set up?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • rsstom

Posted March 05, 2006 - 09:42 AM

#2

You can just trim the plug wire back a little, maybe 1/4 inch. Just make sure it'll still reach the plug. Then thread the cap back on. The wire's probably part of the coil.

  • hondajohn

Posted March 05, 2006 - 11:05 AM

#3

Thats what I was thinking also but wasn't sure if replacement coils were redialy avaible?





Related Content

Forums
Photo

Would a Young Scott Summers still be Competitive today on an XR600R? What would he ride to be competitive today? by Jayzonk


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  158 replies
Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo

Fell Off Trailer by usafxr


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies
Forums
Photo

2015 XR650L Squeaking noise by Crayjay


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies
Forums
Photo

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 7 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.