accel pump (need quick response!!!)



1 reply to this topic
  • higgy426

Posted September 21, 2001 - 03:34 PM

#1

01 wr 426

Problem: The accel pump doesn't seem to be working properly. I took apart cleaned.
no better.
I took a long screw driver and pushed on it while i blirped the throttle and I had immediate response instead of a gasping out ready to die please don't do that again response. lil help please!!!!
mike

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Hick

Posted September 21, 2001 - 06:48 PM

#2

Pushed on what?

Took apart what?

In some cases dirt gets into the passage where the actuating rod sits in the carb body and creates enough of an obstruction to prevent the spring that operates the pump (wrapped around the slide pulley) from being able to push the rod and actuate the pump.

When this happens you need to remove the rod and clean the passage. Smoothing up the rod with some emery paper also helps.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.