Pay attention when cleaning your carburettor!


2 replies to this topic
  • Matty05

Posted February 16, 2006 - 12:13 AM

#1

Found out today that the vacuum release plate was up side down on the throttle slide.
I knew something was wrong, I couldn't find it. The great Burned pointed it out straight up!!!! Kudo's to Burned!

This is how is should go:
http://www.pbase.com.../image/25566144

I went from 52 pilot jet with fuel screw about 3 or so turns out down to
48 pilot jet with fuel screw 1 and 1/4 turns out.

It runs cleaner to say the least, maybe I can try the ACV disconnection again!
Better throttle response! :thumbsup:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Dan_Lorenze

Posted February 16, 2006 - 12:14 AM

#2

Yes........ That's an easy one to do........ Been there done that.. :thumbsup:

  • magnolia_waterboy

Posted April 08, 2006 - 10:05 AM

#3

Yes........ That's an easy one to do........ Been there done that.. :thumbsup:

i've got a question about the seal that fits on the release plate. does the beveled side of the seal supposed to seal against the plate or the slide? I can't seem to find a diagram that describes it. thanks.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.