Woods setup on 06?


2 replies to this topic
  • aedwards07

Posted February 10, 2006 - 02:06 PM

#1

Well I bought new taller bars for MX since thats what I mostly do and I run no handguards on them.I was thinking since I have basically 2 brand new sets of protapers I could make one a woods setup so when I race HS I can just swap the bars out.So I have a few questions.I want to get some 10mm bar mounts to raise my low ProTapers.Who makes a decent set that will not twist everytime I crash?Also I am going to get the Cycra Probend handguards.Should I get the normal metal ones or should I get the new composite ones and why?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • villiage_idiot

Posted February 10, 2006 - 04:56 PM

#2

What kind of composite? If it's a resin or polymer that will deform under immense pressure I'd go with the lighter of the two(metal or composite). If it's a carbon fibre based composite I'd go with the metal. CF is wacky strong, but when it lets go....it literally explodes. Shatter is not strong enough a word for what happens to epoxy/cf laminates when thier envelope is exceeded. It would leave a wad of sharp prongs and other nasties I would not want my hand near.

  • aedwards07

Posted February 10, 2006 - 05:29 PM

#3

I do not believe that the cycra composite probends are made from CF.Is this the correct kit I want for the Tripple clamp mounted probends: http://store.cycrara...m/trclmopr.html





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.