Problems with my hot start

1 reply to this topic
  • sticky146

Posted January 11, 2006 - 09:57 AM


My hot start got all screwed up when I fell in a turn and kicked my carb to get the bike off of me. The plunger was stuck and the cable was full of slack. I took the plunger out and sprayed it with cleaner and put grease on the end. When it was out of the carb, the slack was gone and the action was smooth with the cable but once I screwed the plunger back in, the slack was back with the cable. What should I do?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • MotoGoalie

Posted January 11, 2006 - 10:36 AM


The little plunger is hung up with the o-ring on the lip of the hole it goes into. You got to insure that you shove that plunger into its orifice all the way down (very X rated :bonk: ) before you screw your hot start nut back on . :applause:

I've been through this exact same thing.

Related Content


Should I buy this bike? help....... by Numsa Hul

Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

The "going back to the other darkside" adventure... by Monk

Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies

Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.