Info needed... '04 or '05 YZ450 Clutch arm length.

No replies to this topic
  • motobark

Posted January 10, 2006 - 02:13 PM


Can somebody with an '04 or '05 YZ450 please measure the length of their clutch arm (motor end)? You don't have to take it out or anything, just measure the centerpoints of the arm. Center of shaft pivot to center of cable end hole on the '03 is 35mm, I believe the earlier and later ones were shorter but I'm not positive.
(I'm basically looking at the leverage length of the arm, the longer the arm the easier the pull but also less clutch pushrod travel.)


Related Content


100 hrs on 2014 yz450f, shim valves or replace them? by ttr230rider6

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  79 replies

Thinking about Yamaha 250... by Arctic Pride

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  491 replies

Is it worth it? (Cam and High compression piston) by macgi77

Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies

Michigan Motocross Tires by 288yz450

Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply

Need help by Goforaride

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  68 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.