Exhaust Question


1 reply to this topic
  • khelton

Posted December 27, 2005 - 07:53 AM

#1

I am currently running an FMF Ti pipe w/ FMF header, tried all I can think of to stop an exhaust leak where midpipe connects. I love the FMF can but the exhaust leak I don't love. Does anyone know if a header from another manufacturer would match up with the FMF Can ?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • goblin127

Posted December 27, 2005 - 07:23 PM

#2

I assume that the two pipe's are fitting into each other far enough? One pipe is smaller than the other,maybe to small? How about building the loose pipe up with Jb weld and then sanding to fit. Hate to see ya throw a good pipe away.





Related Content

Forums
Photo

Engine Loping/Sputtering by tcaldwell


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies
Forums
Photo

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 7 replies
Forums
Photo

ignitech programmable XR650L CDI by brianhare


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  60 replies
Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.