Gas tank crossover tube


2 replies to this topic
  • FJT

Posted December 14, 2005 - 01:33 PM

#1

Hi, all;
I have an aftermarket larger-capacity tank on my XR - those of you who know the tanks, know that they are asymmetrical. Anyone work out a crossover tube so that you draw from the low side without going on to reserve?

Thanks,
FJT

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • mtrhd101

Posted December 15, 2005 - 12:24 AM

#2

Kinda tricky to drill and tap a plastic tank for a crossover tube without creating at least a potential future leak.. There are several ways a guy could do it but I would recommend to just stop and lean it over.. :applause:

  • TimBrp

Posted December 15, 2005 - 03:49 AM

#3

It's going to be tough with an aftermarket tank, IMO. Typically the side that the petcock originally resides on is higher than the alternate side. Therefore if you were to put another shut-off on the opposite side the gas would have to go up against gravity then connect to the original line and into the carb. Much easier to lean it over as mtrhd101 has stated.





Related Content

Forums
Photo

XR650L super moto wheels by greggkklee


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  29 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
Forums
Photo

2015 XR650L Squeaking noise by Crayjay


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies
Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo

Engine Loping/Sputtering by tcaldwell


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 4 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.