04 yz450 exaust gasket

2 replies to this topic
  • new2blue450

Posted December 14, 2005 - 07:44 AM


hey, what is the easiest way to get the exaust pipe gasket (the tube one between the header and pipe) on? i destroyed 2 last night.....thanks YZ guru's!

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • grayracer513

Posted December 14, 2005 - 01:58 PM


I'll assume you are installing it on a stock midpipe/header combo? Don't try the seal on any other pipe unless it specifically calls for it.

Get a muffler shop to open up the end of the mid pipe *JUST A LITTLE*. Check the end of the header for a harsh corner and dress it up with a file if you need to. Slip the seal halfway on the header and slide the midpipe on, working the seal into place as you go, then line up the pipe and clamp it down.

  • new2blue450

Posted December 15, 2005 - 09:41 AM


thanks again grey....and once again you were a great help!

Related Content


05 yz450f not fast enough by RedeyeYZ

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  38 replies

BIGBORE FOR YZ450F 2006? by Taattie94

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies

The "going back to the other darkside" adventure... by Monk

Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Wilson the Blue Privateer by jetfuel

Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.