whitebros E2 help

1 reply to this topic
  • billg

Posted October 17, 2005 - 04:25 PM


Has anyone installed this pipe on their xr600? It seems you need less bolts than the original. Once installed, do you need the clamp that went on the original muffler and do you need the heat shield ( I think thats what it is) that goes by the rear disc reservoir. Will the heat from the muffler melt the reservoir? Also, will the clamp still fit or is it not need anymore? Please advise.


Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • justicedone

Posted October 17, 2005 - 06:45 PM


I have a friend who just put one on his 05 650L, and there is no clamp. Its a tapered fit and true slip on. Not real sure about the heat thing, but his did mount too close to the side panel, and I advised him to change the rear shims for clearance. Kinda sticks out far in the back, that always scares me...

Related Content


Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 7 replies

Cle Elum Sunday 5/29: Looking for dual sport tips by TigerTanker

Dirt Bike   Dirt Bike Regional Discussion   Northwest
  • Hot  32 replies

XR650L super moto wheels by greggkklee

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  28 replies

1993 XR600R rebuild by ove

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  40 replies

Post Apocalypse, ThumperTalk style! by Justin Pearson

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  35 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.