Bent Bars



1 reply to this topic
  • Mike_from_WA

Posted August 16, 2001 - 10:38 AM

#1

I have a set of Renthal bars that took a fairly good hit on one side in a "high side" spill. :D The bars are slightly bent back and down on one side. It is noticable but just barely.

Has anyone had any success straightening out bent aluminum bars? If so how? :D

I suppose if I ride with them this way long enough I probably won't notice it as much. :)

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • 696

Posted August 16, 2001 - 11:02 AM

#2

I had a pair of Moose bars I bent back by removing my hand guard and placing a steel rod about 5" into the bar end. I placed the steering in full lock and pushed the rod until the bars were striaght. It helps to have a buddy hold the bike.
696

------------------
2001 YR 426, YZ# Plate, YZ Fender, YZ pipe, YZ Tank, SDG YZ Seat, 13/50 Gearing, Pro-Taper Bars, TAG Triple Clamp, Moose Handguards, Maier Frameguards, Works Connection Radiator Guards, Michelin M-12, Throttle Stop Trimmed, Air Box Lid Removed, Gray Wire Mod.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.