dent puller used on oil seal?


1 reply to this topic
  • FULTWST

Posted August 20, 2005 - 01:31 PM

#1

I need to replace a oil seal on the counter shaft of my '96 XR600. I was told an easy way to do this is with a small dent puller and a small drilled hole in the seal itself. Anyone try this before? What other techniques are there for an easy extraction? Does the new seal tap in with a mallet? I want a tight seal about as much as a horny walrus. Thanks for any input... ~Paul

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • roadcam

Posted August 20, 2005 - 02:40 PM

#2

I've used a dent puller for removing seals, works fine... hopefully, the old seal will come out in good shape ... just flip the old seal over, place it on top of the new seal, and use it as a buffer to tap in with a hammer ... saves wear and tear on the new seal ..





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.