removing throttle cables (Edlebrock install)

2 replies to this topic
  • honkylips

Posted July 18, 2005 - 10:48 AM


Can somebody give me a crash course on removing throttle cables. I'm trying to install an edlebrock carb. While I'm somewhat handy, my experience working on bikes is similar to my experience in winning lotteries.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • irondude

Posted July 18, 2005 - 10:53 AM


1) take off seat, tank
2) loosen carb from intake manifold and airbox boot.
3) rotate carb loose from manifold and boot.
4) remove cables from top of carb.
5) note routing of cables--then remove entire throttle and cables from bike.

install edelbrock in reverse.

  • Ramcc4x4

Posted July 18, 2005 - 11:02 AM


Loosen the two phillips head screws on the throttle tube assembly. Remove the stock throttle assembly from the handlebars. When I switched carbs I left the throttle assemblies attached to the carb. Like mentioned above, pay attention to the routing of the cables. When reinstalling the tank be sure the throttle cables do not get caught on the left side of the fuel tank.

Related Content


Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 7 replies

2015 XR650L Squeaking noise by Crayjay

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies

ignitech programmable XR650L CDI by brianhare

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  60 replies

Fell Off Trailer by usafxr

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies

Engine Loping/Sputtering by tcaldwell

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.