float level

1 reply to this topic
  • ncmountainman

Posted July 10, 2005 - 09:22 AM


so after fighting with my jetting for a month i've finally got it right(40pj,100paj,DWR 5th,165mj,40lj) but the problem with stalling in the technical stuff is still there. i beleive its the float level,because i just noticed it dripping gas if i accellerate hard and then stop. so the question is which way is out? is the float too low and not closing the needle or is it too high and allowing it to overfill. the manual does not state which way to bend the tab for this situation just the measurement to set it. it may just be hanging up as i've been poking around changing jets so much. but i'd like to know which way to bend the tab to lower the fuel level? thanx ncmm

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • MisterMan

Posted July 10, 2005 - 10:05 AM


bend tab up to decrease the amount of fuel in it.

Related Content


Chubby dad, looking at bikes , First trip to the orange/black forum ! by Slow_ride

Dirt Bike   Make / Model Specific   KTM   250-530 EXC/MXC/SXC/XC-W/XCR-W (4-Strokes)
  • Hot  28 replies

Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies

First Hare scramble tips by dhend8

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies

YZ450F 03 Sparks driving me crazy by SirAttard

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 5 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.