Clutch Change


5 replies to this topic
  • iestrada

Posted July 09, 2005 - 02:19 PM

#1

I just cahnged the sluctch fibers on my brp, added an extra plate right next to the one closest to the cover (is this position ok?) But now I need to pull all the adjustment in both ends of the clutch cable, fo rthe lever to engaje. Is this right or Did I do something wrong?

  • XR4DEZ

Posted July 11, 2005 - 02:25 PM

#2

Pull out everything to the basket and install (OEM)7 steel and 6 fibers, starting with a steel and alternating.

  • iestrada

Posted July 12, 2005 - 12:56 PM

#3

Should I discard the narrow fiber (the one that has the bigger inside diameter) along with the "busshing ring"? And put instead a normal fiber?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • XR4DEZ

Posted July 12, 2005 - 02:39 PM

#4

Take everything out to the basket, last fiber, judder, etc.

  • SaltyWalrus

Posted July 13, 2005 - 02:09 AM

#5

I just got my Tusk clutch kit and am ready to throw it in. I may decide to just throw in an extra steel plate to see how much more life I can get out of the stock plates. So where do I throw it in? XR4Dez, you say 7 steel and 6 fiber. How does that compare to stock?

  • XR4DEZ

Posted July 13, 2005 - 01:51 PM

#6

Stock is 6and 6 with the judder and everything else. The stack that I use is the same as Honda Off-Road's 650.It pulls better than stock and allows you clutch control right at the begining of the pull. Remember to leave a good 1/2 inch of free play in the lever.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.