[FCR 41] Hesitation on deceleration


1 reply to this topic
  • brad762

Posted May 28, 2005 - 11:17 AM

#1

Hi to all.
Like my friend atreiu, I have a '91 XR 600r with 644cc, worked head, hotcams and open exhaust. The pumper is a 41mm FCR, the jetting is the same suggested in the thread, except the main jet (#185).
I have the following issue: on acceleration and at full throttle all works perfectly, but when i decelerate (also slightly), the engine becomes very irregular, and it pops. Then I have to close and reopen throttle completely, if I want that the problem ends. What happens?

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Rover31

Posted May 28, 2005 - 04:57 PM

#2

my fcr came very lean. I put in a larger idle jet, I think if I remember I started with a 48 and ended up with a 60 or 62 I can't remember for sure.
If you go to sudco.com they should be able to help you.
Good Luck
Travis





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.