Kick start installation problems!


No replies to this topic
  • XRGUY79

Posted May 09, 2005 - 01:01 PM

#1

Hello there I need some help Im installing my kickstart shaft assembly on my 2003 xr 650R. I don't know if that stopper paw on the rachet section is suposed to be positioned up so it touches the plate at the 11 oclock positon or should it even be behind the plate at all. Im guessing it goes at the 11 oclock position behind the stopper plate thing.

Thanks
The repair manual doesn't say much





Related Content

Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo

ignitech programmable XR650L CDI by brianhare


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  60 replies
Forums
Photo

Would a Young Scott Summers still be Competitive today on an XR600R? What would he ride to be competitive today? by Jayzonk


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  159 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
Forums
Photo

2015 XR650L Squeaking noise by Crayjay


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.