Cylindrical washers on carbureter hose clamps

No replies to this topic
  • JeffWR

Posted April 23, 2005 - 05:24 PM


I just got done installing the JD Jetting kit and when tightening the clamps up they bottom out with the washers installed. I can still slightly rotate the carb mostly due to the clamp nearest the cylinder. Any problem of just removing the washers which I did do? I assume they don't want the rubber to buckle from overtightening the screws.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.