cluth help please

6 replies to this topic
  • neversummer

Posted April 17, 2005 - 03:41 PM


I just installed new clutch plates on my 01 426 everything was working fine before the installation but after a diff. story the clutch isn't working. I put it in gear pull the clutch and it's like it needs adjusting. I have also yet to get it to start w/new plates much resistance while kicking, even noticably more resistance w/comp. release pulled. It has a magura hydraulic lever, it doesn't feel right now either.

  • biznet1

Posted April 17, 2005 - 04:54 PM


Did you soak the plates in oil?

  • neversummer

Posted April 17, 2005 - 05:20 PM


yes I did

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Satch0922

Posted April 17, 2005 - 05:26 PM


did you make sure to reinstall the "ball" at the end of the clutch rod ?

  • neversummer

Posted April 17, 2005 - 05:28 PM


I didn't pull the rod just replaced plates

  • PumpkinHumper

Posted April 17, 2005 - 06:19 PM


You do know that one of the plates is differant from the rest. The inside diameter is diferent than the rest. If it isn't in the correct order you will have isues.

  • neversummer

Posted April 20, 2005 - 07:02 PM


the old plates did not have any notches in the tabs: new ones did, I asked around and several people said that the notches need not be lined up, several people were wrong!

Line the notches up, works like a champ.

Related Content


Is it worth it? (Cam and High compression piston) by macgi77

Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies

First Hare scramble tips by dhend8

Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  33 replies

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F

Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies

yz400f throttle bog by yz400fmaniac

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • * * * * *
  • Hot  28 replies

100 hrs on 2014 yz450f, shim valves or replace them? by ttr230rider6

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  79 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.