Removing headlight from WR250F.


1 reply to this topic
  • KiwiRacer

Posted April 16, 2005 - 08:12 PM

#1

Hi,I want to YZ my WR & there is heaps about doing it BUT Can anybody tell me what is the BEST way to remove the headlight from the WR so that you can run a YZ numberplate.Can you unplug the on/off switch? or just move it to another place?? Also I've got a 04 WR I guess that you have to run 04/05 numberplate/Rear fender plastic?? I've looked for info on TT but have not found any information on any forums about doing this. :naughty:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • black_n_blue_thumper

Posted April 16, 2005 - 08:18 PM

#2

YZ plastic goes right on. Some very minor dremel work needed on the rear fender. It is very easy. I just un-bolted my WR number plate and put a YZ plate on the front. There have been many good sugestions on how to best do this. I just used the empty bolt holes on the bottom, ran my brake line outside (like they do on a YZ) by removing the upper brake line "retainer". I then just use a cable tie to hold her in place. I didnt move my ignition botton, just worked around it. Get the parts and go to work, it will just fall into place. Good luck. :naughty:




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.