rear wheel bearing...xr650-r


1 reply to this topic
  • djinnzfree

Posted March 20, 2005 - 07:56 AM

#1

is it easy to perform a change?
need special tools?
is there c-clip for retaining bearing?

did anyone got the numbers who's write on the side of the bearing... just to check if i can find something as jobber one...

thanks...

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • TimBrp

Posted March 21, 2005 - 04:12 AM

#2

I used a bearing punch for mine. If you look down your axle shaft there is minimal rooms to work around the collar and actually tap at the bearing. You'll need, I believe, a 20mm punch and they'll come right out. Make sure you pack the new ones with grease.





Related Content

Forums
Photo

ignitech programmable XR650L CDI by brianhare


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  60 replies
Forums
Photo

Engine Loping/Sputtering by tcaldwell


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies
Forums
Photo

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 7 replies
Reviews

Honda XR650L 2016 by Chris.GVS


Honda XR650L 2016
  • - - - - -
  • 0 reviews
Forums
Photo

2015 XR650L Squeaking noise by Crayjay


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.