Generator cable covering.


1 reply to this topic
  • NevadaCR500

Posted February 17, 2005 - 08:30 PM

#1

What wraps around the generator cable where it goes through the case? I purchased my 426 used and it has always had the wires exposed right before they go through the case, I noticed on an 05' 450 that there appears to be some type of black tape. But not having another 426 to look at I'm not sure what was on there when it was new. By the way the generator cable is the one on the left side of the motor near the timing mark hole.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • tammie

Posted February 18, 2005 - 09:23 AM

#2

the wire should be cmoing out of the generator cover through a rubber plug....then what i did was a wrapped my wires with the plastic according wire protector then i electrical taped around that all the way to the end of the wires.........then i even used some "liquid electrical tape" near the rubber plug just for added water proofing, that liquid electrical tape is like a paint on black liquid stuff that drys flexible.........great for hard to tape areas that you want to keep protected and waterproof........





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.