canadian wr426 jetting help!



2 replies to this topic
  • gap

Posted August 06, 2001 - 01:00 PM

#1

There are so many posts on jetting here I'am getting confused.
Please help narrow it down.
My engine stumbles badly aprox.1/8-1/4 throttle. 0-1000' , over 5000' it is almost unrideable.

-'01 wr426 canadian model
-FMF power core IV
-air box cover removed
-wr timing
-stock jetting
-42 pilot -1 7/8 turns out
-DQR needle 4th clip
-165 main
-200 main air jet
-75 pilot air jet
P.S. local dealer will not look at the bike unless it is stock.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Jason_Williams

Posted August 06, 2001 - 02:10 PM

#2

FIND A NEW DEALER!!!!!!!!!!!!!!!!!!

  • James_Dean

Posted August 06, 2001 - 09:35 PM

#3

Try a leaner clip position. The "Q" in DQR gets the taper on the needle cut very high (rich) and the leaner clip position will move the needle down closer to an acceptable range for high altitude riding.

Q-R-S-T-U-V are 1/2 clip each

You are using DQR clip #4, equivalent to DVR#6+(1/2). Looks like DQR#3 or #2 would be better.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.