clutch basket and rekluse ??


No replies to this topic
  • GetSumBaby

Posted January 26, 2005 - 06:08 PM

#1

I will be putting in a new clutch and z-start tomorrow and I have a couple of questions.
First - How can I get the basket off without a clutch holding tool. Is there another way?

Second - I don't have an inch pound torque wrench. How else can I get these screws to 96 inch pounds? How tight is that?

Next - When putting the z-start on, It says to remove the seat plate and the clutch damper spring next to the basket and also remove the outer most clutch plate and friction disk. Right?

Any other help/tips will be great!!

Ed





Related Content

Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Is it worth it? (Cam and High compression piston) by macgi77


Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies
Forums
Photo

Chubby dad, looking at bikes , First trip to the orange/black forum ! by Slow_ride


Dirt Bike   Make / Model Specific   KTM   250-530 EXC/MXC/SXC/XC-W/XCR-W (4-Strokes)
  • Hot  28 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.