motor rebuilding specs

1 reply to this topic
  • nicogc

Posted January 11, 2005 - 06:14 AM


hello everryone!! do any of you know if there is somewhere on the web where i can download a shop manual for a XR600R '98-'99, or where ca i find information for specs on compression tests, cilinder diameter, ring clearances, etc. i want to know if i have to rebuild the top end on the bike. thank you very much for any info you can send me.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • bootlegger2

Posted January 14, 2005 - 03:42 AM


well if it smokes while you are ridin it needs rebuilt i dont know about compression i would say anything above 150 is good ring clerances if you got it down .003 per inch of bore a 4 inch bore needs a .012 ring gap
i havent realy looked for any web sites with the info you want though maybe the honda web site can give you a spec sheet about it when it was new bore stroke stuff like that

Related Content

Want to add a kickstart to your XR650L?  Here's how - last post by clc3251

Want to add a kickstart to your XR650L? Here's how

  • 1 reply

ignitech programmable XR650L CDI by brianhare

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  60 replies

Honda XR650L 2017 by Chris.GVS

Honda XR650L 2017
  • - - - - -
  • 0 reviews

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 9 replies

93 xr650l Restoration Project by Zigster

Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.