1004 cc 450 on NOS.


2 replies to this topic
  • yz426onNOS

Posted January 10, 2005 - 09:00 PM

#1

I have come up with what I want my new bike to be!

It is going to be all custom and frankenstine built!

I'm thinking to wr motors (need the wide ratio trans and the E start)

In a yz frame that is streched to fit them.

I'm thinking around 140 horse power.:cry:

NOS, cams, bored, stroked, pipe, silencer, air filets and box mods, clutch basket, water pump, pump cover, impeller, micro polished tranny, cdi, carb mods, ported and polished, suppension, new rear wheel assembly, and maybe higher compression.

I think i'll build her for sand drags and super hill climbs.

Then i'll pick up a xr650 to use for normall fun rides and do minor mods to it.


So what do you guy's think?

I think thoses open class 2-smokes at glamis are going to be eating a lot of thumper sand!:cry:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Indy_WR450

Posted January 11, 2005 - 12:16 AM

#2

I think that paddle tire is going to get paddles torn off without steel reinforcements!:cry: Wow 140 HP dirt bike!:cry: I guess that would be like putting knobbies and paddles on my R1 and going for a blast in the desert!:cry:

  • Idaho_Wolverine

Posted February 08, 2005 - 08:11 PM

#3

My idea.......

Have you seen the KTM RC8? Its a bad as$ V-twin, light and nimble.

Now let us take a couple of 2003 YZ450F motors and they can share a crank..

Add a 6 speed tranny from an FZ1/R1 and put it in a nice Buell XB-R frame!!

Just think, a shorter wheel base than the current GP bikes, no fuel tank (its in the frame) and a dry oil sump ( the oil is in the swingarm)

BUT, no Nitrous for me! The front wheel will be off the ground too much as it is!!





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.