yz cylinder


2 replies to this topic
  • my98mugen

Posted January 10, 2005 - 08:09 PM

#1

im putting new rings in my wr400 thats never been opened before. the cylinder walls are clean with no scores. i can still see the old cross hatches.

my question is, do i need to hone the cylinder before i put in the new rings or are those walls to hard to even make a difference?
_________________
Desert F240
GP F118

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • yz426onNOS

Posted January 10, 2005 - 08:49 PM

#2

You still need to hone it. A glaze breaker will work just fine. Also use normall dino oil for brake in. Don't use synthetic! Good job mang!

  • yzf450jack

Posted January 10, 2005 - 08:50 PM

#3

Sure run a hone in there to clean that glaze off not to much so your new ring can seat faster:thumbsup:





Related Content

Forums
Photo

2016 YZ450 by CaptainKnobby


Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies
Forums
Photo

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F


Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Michigan Motocross Tires by 288yz450


Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply
Forums
Photo

The "going back to the other darkside" adventure... by Monk


Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.