650R Banjo Bolt Pitch


3 replies to this topic
  • YZFnwithme

Posted January 07, 2005 - 02:33 PM

#1

I'm planning to purchase one of those pressure activated brake light switches, which essentially replace the banjo bolt that attaches to the front brake master cylinder. I know that the bolt is single bleed, 10mm .... but is the pitch 1.0 or 1.25? Here's a link to the item:

http://www.motostran...m/hybrlisw.html

Thanks.

  • JackAttack

Posted January 07, 2005 - 03:12 PM

#2

This might help. :cry:


:cry:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • YZFnwithme

Posted January 08, 2005 - 06:17 AM

#3

O.K., so that link confirms that the rear takes a 1.25 .... what are the odds that the front is the same? Pretty good, I'd think.

Anybody know for sure?

  • qadsan

Posted January 08, 2005 - 11:29 AM

#4

It's definitely the same as the rear. I just didn't remeber the pitch for certain, but I do remeber both the front and the rear were the same when I meshed the threads together to check them out before I installed them. I also did not need to bleed my brakes, but I know of others who had to.





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.