Fork Seals.....DIY?

1 reply to this topic
  • rakkno

Posted January 07, 2005 - 12:38 PM


Anyone done their own for seals on A 2001 YZ 426. I was going to take it in but figure I am going to keep this thing for a bit and would like to learn how. :cry:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Throttle_monkey1

Posted January 07, 2005 - 12:45 PM


Its a piece of cake dude. If you have a manual you should be fine. Showa twi chambers (like on my CRF) are more difficult, but even those aren't too hard. Pick up some 2 inch PVC pipe and cut it down the middle to make a home made seal driver.

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.