Acerbis + Pro-taper = Can't use 'em


3 replies to this topic
  • matt_patton

Posted December 31, 2004 - 08:38 PM

#1

I'd like to use my Acerbis hand guards but they don't work with Pro-Taper bars because of the radii issue. I looked high and low on Acerbis website to no avail. Don't they have brackets that will work with oversized bars? If nothing else I'll add it to my project list for the mini-mill. Nothing a boring bar can't solve.

  • Birdie426

Posted December 31, 2004 - 08:48 PM

#2

You have two options...Acerbis does sell some brackets for use with pro taper bars. See this link from Chaparral ...

http://www.chaparral...6C46B87E6DF8196

or you can get some tripple clamp mounts from MSR, again thru Chaparral at this link
http://www.chaparral...6C46B87E6DF8196


Birdie

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • matt_patton

Posted January 01, 2005 - 07:10 PM

#3

hey, cool. thanks. But at $29 I think this just became a project for the mill. Being able to make/modify your own stuff is dangerous.

  • Birdie426

Posted January 02, 2005 - 09:20 AM

#4

I would go the triple clamp route. Easier to mill, and it seems that my tapered bar clamps don't stay positioned real well when you use the bark busters for their intended purpose. On a ride not too long ago, I drug the throttle side on the ground (but still managed to save the get off), the bark buster and clamp rotated so far that it kinked the break line!




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.