XR650L:Handlebar Question?


1 reply to this topic
  • bluerock5

Posted December 15, 2004 - 01:50 PM

#1

I put on a new Renthal Handlebar and the Horn/Hi-low Beam control by the clutch lever has a pin on it that fit into a hole on the orginal handlebar - and the new handle bar does not have one - is it OK to just cut off the pin so it fits flush or should I drill a hole in the new handlebar to sink the pin into.

Thanks

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Beerad

Posted December 15, 2004 - 02:01 PM

#2

do not drill the handlebar, you can shave the pin down with a file and just leave a little bit of it, maybe a 1/16 or so, this will help keep it tight.





Related Content

Reviews

Honda XR650L 2016 by Chris.GVS


Honda XR650L 2016
  • - - - - -
  • 0 reviews
Forums
Photo

Fell Off Trailer by usafxr


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
Wiki
Want to add a kickstart to your XR650L?  Here's how - last post by clc3251

Want to add a kickstart to your XR650L? Here's how


Articles
  • 0 replies
Forums
Photo
Supercross

Supercross Preview 2017 Part 1: Championship Contenders by Chris Cooksey


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  132 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.