gray & blue wire switch type

1 reply to this topic
  • Neutron

Posted November 30, 2004 - 09:48 PM


I just upgraded from a YZ400 to WR426 and I would like to install toggle switches for my gray and blue wires instead of just cutting them. I have switches rated 3A at 125VAC or 1A at 250VAC. Are these too small? I don't know what amperage or voltage runs through those wires. Anybody have any other suggestions for a toggle? Thanks!

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Endurordr

Posted December 01, 2004 - 07:08 AM


I bought a factory Yamaha headlight switch for the older WR's and used that as my toggle switch for the gray wire.


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.