3 replies to this topic
  • spanner

Posted November 05, 2004 - 11:27 PM


did pads and change brake fluid tried to bleed but cannot get them to work any ideas

  • ncmountainman

Posted November 06, 2004 - 06:50 AM


you have to put a clear hose on the bleeder valve into a cup of clean brake fluid,make sure the end stays in the fluid at all times. crack the bleeder compress the lever and hold,while holding the lever in, close the bleeder. repeat until air bubbles are no longer present in the hose. be careful that you don't empty the master cylinder(keep adding fluid) its way easier with two people,just pay attention because any deviation will allow air back in!! :cry: :cry:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Indy_WR450

Posted November 06, 2004 - 06:57 AM


Go to autozone and buy a cheap vacuum bleeder. Makes the whole process a lot easier! :cry:

  • spanner

Posted November 06, 2004 - 05:44 PM


thanks guys got them working :cry:


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.