xr600 axle diameter



5 replies to this topic
  • WebCrush

Posted June 27, 2002 - 07:52 AM

#1

Anyone know the front axle diameter for a '95 XR600?

Thanx

  • Moredesert

Posted June 28, 2002 - 05:31 PM

#2

The best I can tell it's 12mm. I don't have a 600 anymore but I do have a set of rear wheel bearing on the shelf. The drive side that takes the spacer is a 6204 and the brake side is a 6203. The ID is the same size as the axle and that works out to be ~.670/in or 12 mm.

  • Moredesert

Posted June 28, 2002 - 05:37 PM

#3

Sorry you said front axle :) Same thing the front bearings are 6003 and is also 12 mm

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • WebCrush

Posted June 28, 2002 - 07:22 PM

#4

thanx, but i just found another source and it states 17mm just like the xr400.

you sure you measured right? :)

  • Terrain Rider 4z

Posted June 28, 2002 - 08:55 PM

#5

There are about 2.56 cm in one inch, if you convert that to mm you get 25.6 mm. Multiply that number by .67 and you should get 17.152 mm. :)

  • Moredesert

Posted June 29, 2002 - 07:45 PM

#6

Well I'll be. :) :D I took the caliper and compared it to a metric tape measure. I guess I can't see stright. Like I said 17mm. :D :D :D





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.