hi-comp xr6



1 reply to this topic
  • tterb

Posted May 25, 2002 - 06:44 PM

#1

I need a top end rebuild on my 96xr6 and am wondering about putting in a 10:1 prox piston kit?Any advice would be appreciated.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • XR6's_rule

Posted May 25, 2002 - 07:38 PM

#2

High comp pistons are always heavier than stock, so there is that trade off, also they stress the bottom end a lot more than a stocker. I weighed a stock & a JE high comp piston and the stocker was about 15% lighter than the high comp one! When I rebuilt my XR6 I shaved the head 20 thou (0.5mm) and tidyed up the inlet port. This made a big difference in power with no loss in reliablity thus far. Good luck with it! :) :D





Related Content

Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo

Fell Off Trailer by usafxr


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies
Reviews

Honda XR650L 2016 by Chris.GVS


Honda XR650L 2016
  • - - - - -
  • 0 reviews
Wiki
Want to add a kickstart to your XR650L?  Here's how - last post by clc3251

Want to add a kickstart to your XR650L? Here's how


Articles
  • 0 replies
Forums
Photo

Post Apocalypse, ThumperTalk style! by Justin Pearson


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  35 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.