Allen Bolt sizes for carb on 94 XR650L


4 replies to this topic
  • 1biglung

Posted September 28, 2004 - 01:16 PM

#1

I am going to replace the bolts on my carb with allen bolts.
Could someone list the sizes. I would like to pick them up on my way home and not leave the carb apart all night.

Thanks, Chris

  • XR650L_Dave

Posted September 28, 2004 - 01:43 PM

#2

Shoot, I used to know...
They're real cheap at home depot, I just grabbed an assortment.

Don't forget to do the standard mods (drill, shim, de-snorkel, etc...). Of course, that's probably why its apart...

Dave

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • 1biglung

Posted September 28, 2004 - 01:52 PM

#3

Correct Dave, I am going to Drill and Shim.

Also looking for the shim dimensions. Would you happen to know off hand?

Thanks

  • XR650L_Dave

Posted September 29, 2004 - 09:06 AM

#4

0.030 inches thick, quite small in outer diameter. It needs an inner diameter that'll let the needle through, and an outer diameter that'll let it go down into the little 'well' at the bottom of the slide that the needle fits into.

Dave

  • 1biglung

Posted September 30, 2004 - 10:40 AM

#5

:cry:
#4 washer
4-4mm X 10mm
4-4mm X 16mm

did the trick thanks.

Chris :cry: :cry:





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.