------------CLUTCH FIX (6mm lock washers) need HELP------


3 replies to this topic
  • brown77

Posted September 27, 2004 - 08:20 AM

#1

On sunday I installed the lock washers in my clutch they said 1/4 inch on the bag I am guessing that ment 1/4 wide not thick.They look like they are about as thick as a thumb nail, does that sound right.They fit INSIDE the clutch spring and rested on top of the tower.I used the calipar at home depot to measure them and it said 6 on the dial but I could not figure out for sure if that was right (never used on before)

Let me know if that sounds right

Thanks a lot :cry:

  • brown77

Posted September 28, 2004 - 08:04 AM

#2

to the top :cry:

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Fastest1

Posted September 28, 2004 - 10:27 AM

#3

The 1/4" measurement is probably the diameter of the hole in the center, if it measured a 6 on your calipers it is 6mm, a little over a 1/4" thick. Did it say .006? Check to see what scale you were in. What kind of problem were you having that made you shim the springs? Slipping? I cant see why you would install the washer on the towers and not under the washers. If you put the washers on the towers it should decrease the amount your pressure plate will go in to compress the plates. Might not be an issue but could cause problems. Are you running an auto clutch? That is the only place where I have seen them shim the towers.

  • brown77

Posted September 28, 2004 - 11:22 AM

#4

this is where I got it form:
http://www.thumperfa...clutch_mods.htm

79-Cent Fix for “Grabby” Clutch

thanks :cry:

they look more like 1/8 in thick lock washers :cry:





Related Content

Forums
Photo

05 yz450f not fast enough by RedeyeYZ


Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • Hot  38 replies
Forums
Photo

Snake pit oct 30th by The Anvil


Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies
Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Is it worth it? (Cam and High compression piston) by macgi77


Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies
Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.