'01 YZ426F Ring Question


No replies to this topic
  • SCORPiON5150

Posted September 06, 2004 - 06:12 AM

#1

Looking at my piston and rings I noticed that the oil ring (the one at the bottom of the piston) sits close to flush with the outside diameter of the piston, whereas the other 2 rings stick out much further. Is this normal or do all the rings usually have the same diameter?





Related Content

 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.