Tips needed on replacing clutch cable

2 replies to this topic
  • MichiganMXer

Posted August 20, 2004 - 09:23 AM


I couldnt find anything in the manual about replacing the clutch cable, maybe its because its so damn simple; i just dont want to screw it up. 2001 yz426. I'm also replacing perch and lever. thanks.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • yzf450jack

Posted August 20, 2004 - 08:01 PM


:awww: :D :lol: :lol: :thumbsup: :devil:

  • Hamish

Posted August 21, 2004 - 03:20 PM


I just did mine. I can recomend a pivot assisst lever and a venhill(??) cable. The clutch on my 01 426 is now ultra light. The only downside of the pivot assist lever is that it needs a fraction more travel to disengage.
Procedure: release the adjuster at the bars, remove the cable end. Release the adjuster at the crankcase, remove the cable. Fit new cable making sure you route it the same way as the old one. Adjust both ends for a few mm of freeplay at the lever

Related Content


Need help by Goforaride

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  68 replies

Is it worth it? (Cam and High compression piston) by macgi77

Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies

2016 YZ450 by CaptainKnobby

Dirt Bike   Dirt Bike Technical Forums   Suspension
  • Hot  59 replies

yz250x vs 450 4t comparisons (preferably desert riding) needed by JakeNorthrupYZ450F

Dirt Bike   Make / Model Specific   Yamaha   Yamaha 2-Stroke
  • 9 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.