Split in metal tank


No replies to this topic
  • FOUR STOKED

Posted August 04, 2004 - 08:54 PM

#1

Any one have this trouble on their 650L. Mine split in the radius of the bend right in front of where the upper and lower parts are seam welded together for about a quarter inch. I had a plastic tank on it but the wear and tear had it looking pretty ratty and yellow. Was taking a 200 mile strictly pavement trip so I cleaned up the rest of the bike, repaired the dents in the metal tank and repainted it. I did not see the crack until a really nasty bubble appeared in my new based/cleared tank. :shocked:Took the trip any way as the crack up high just behind the tripple clamp, just did not completely fill up at gas stops. :thumbsup:





Related Content

Forums
Photo

Engine Loping/Sputtering by tcaldwell


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies
Forums
Photo

93 xr650l Restoration Project by Zigster


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 17 replies
Forums
Photo

Wiseco 101MM Spark Knock Low Engine Temps by imandrewparks


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 7 replies
Forums
Photo

Would a Young Scott Summers still be Competitive today on an XR600R? What would he ride to be competitive today? by Jayzonk


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  158 replies
Forums
Photo

Fell Off Trailer by usafxr


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  43 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.