XR650L carb dumping gas


9 replies to this topic
  • XR650LKJP

Posted July 31, 2004 - 11:45 AM

#1

Can anyone help?. Riding the other day, my 650L started dumping gas out of the carb and stopped running. I did a trailside pull of the carb and pulled the float bowl. The float seemed to move fine. I cleand the carb very well and put it back in. The bike started no problem and off I went. About 15 minutes later, same problem and same solution. I rode the rest of the day with no problems. However, as I pulled up to the truck, it started dumping gas again although it ran fine. Based upon the excessive gas use for the day, I assume it dumped gas out the overflow most of the day. Any idea?. Do I need a rebuild? The carb looks good inside and the jets are clean. There is no evidence of gas having turned to sludge with the previous owner. I have the dynojet kit on the bike with a 165 main jet. The air box snorkle is removed with a good filter. I also have the BigGun Quiet pipe. Thanks in advance.

  • Buckarmadillo

Posted July 31, 2004 - 03:37 PM

#2

It seems like your float is sticking open. The needle may be getting crud out of your tank and blocking it open or your float is hanging up in the open position. Drain the gas from the tank and pull the petcock. Check the screen to make sure it isn't ripped letting crud through it (I assume it has a screen???). Next put a light in the tank and make sure it isn't flaking rust or crud from the bottom. Put an inline fuel filter between it and the carb inlet. Check your float to make sure it isn't hanging up somehow. You can replace just the needle so you might want to try a new one.

  • BRP27

Posted July 31, 2004 - 04:32 PM

#3

I had the same problem this weekend with a XR650R. See the post on XR650R/Stuck Float/Overheating.

  • XR650LKJP

Posted July 31, 2004 - 06:25 PM

#4

Thanks, the screen looks fine and I made sure the new Clarke tank did not have any plastic flakes in it. The needle is new and I can't get the float to bind or stick. I will keep at it.

  • yooper_porkchop

Posted August 01, 2004 - 01:47 AM

#5

had the same thing happen to me once on the trail, all I did was loosen the carb bleeder screw and let some fresh fuel flush out the bowl, hasn't happened since, go figure.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • Clumster

Posted August 02, 2004 - 05:07 AM

#6

Just an idea, but since you have the DJ kit with the 165 main, do you also have the 'long' 55 pilot? The 'long' pilot can touch the slosh baffle. You may need to either trim the slosh baffle, or get the 55s (short) pilot jet.

You may have already checked that, but just in case.

Fun Ridin'! :thumbsup:
Mike in KC

  • XR650LKJP

Posted August 02, 2004 - 05:33 PM

#7

Mike:

I did not change the anything but the main jet so I don't think so. I will look again anyway since I am going to open the carb up again to see if there is any crud that could be causing the needle to stick. I will also adjust the float at the same time. Thanks for the tip.

  • uw153

Posted August 04, 2004 - 07:00 AM

#8

Yup, gotta be somthing in the float needle area. You might want to increase your pilot to a 55 or at least a 52 also. That wont help the overflow issue but it will help the running and throttle response. :thumbsup:

  • XR650LKJP

Posted August 06, 2004 - 08:04 AM

#9

Thanks, I am digging into it this weekend. I am both cleaning the carb and adjusting the float. When the bike is not dumping gas, it runs perfect. I will let you know the results.

  • Buckarmadillo

Posted August 06, 2004 - 04:24 PM

#10

The float in my XRL carb is plastic and not really adjustable. Pull the pivot pin out and really check the float needle and seat with a magnifying glass (or one of those nifty ring lights with the magnifying glass center). Make sure that there are no burrs hanging anything up.





Related Content

Forums
Photo

XR650L super moto wheels by greggkklee


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  28 replies
Reviews

Honda XR650L 2017 by Chris.GVS


Honda XR650L 2017
  • - - - - -
  • 0 reviews
Forums
Photo

2015 XR650L Squeaking noise by Crayjay


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies
Forums
Photo

DirttyPig 2005 Xr650l Prroject! by braapmebb1moretime


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 22 replies
Forums
Photo

Which thumper motor for a street tracker? by woz


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • * * * * -
  • Hot  29 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.