Owners of Hebo hydraulic clutches...



2 replies to this topic
  • motousa

Posted May 15, 2002 - 03:12 PM

#1

Hey ya'll, I jsut got done putting this unit on to my four-two-six....and it doesn't seem to be pulling the clutch actuation arm far enough to engage the clutch completley. Did anyone else have this problem? I thought that adjusting the piston furthere back in the slave I would be able to eliminate this but no luck. Any help please! :)

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • PK

Posted May 16, 2002 - 05:21 AM

#2

Try adjusting the cable where it comes out after the slave cylinder. It sounds like your slave cylinder is maxed out. The slave cylinder should reset itself to a more neutral position once you get the adjustment in the ball park.

PK
02 426

  • MX_Tuner

Posted May 16, 2002 - 06:18 AM

#3

I think PK is right on the money. Either that or adjust the lever stop so the lever goes out farther and adjust the pushrod clearance to compensate for that.





Related Content

Forums
Photo

James Stewart back on a YZ450F by YamaLink


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  47 replies
Forums
Photo

Michigan Motocross Tires by 288yz450


Dirt Bike   Dirt Bike Regional Discussion   North
  • 1 reply
Forums
Photo

Is it worth it? (Cam and High compression piston) by macgi77


Dirt Bike   Make / Model Specific   Honda   CRF 150/230 F/L
  • Hot  36 replies
Forums
Photo
Supercross

Wilson the Blue Privateer by jetfuel


Dirt Bike   Special Interest Forums   Pro Racing
  • Hot  50 replies
Wiki
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info


Articles
  • 0 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.