Installing a Hinson clutch basket., pressure plate and EBC plates

2 replies to this topic
  • Florida_426

Posted April 08, 2004 - 03:54 AM


I am ready to install a new Hinson clutch basket and pressure plate along with EBC clutch plates and springs. Any input and advice would be appreciated. The bike is a 2002 YZ 426FP. The oil has been Yamalube 4R, and has been changed religiously. Your input will be appreciated.

Bill Barnard

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • slowmotoxer

Posted April 08, 2004 - 04:45 AM


Be sure to use the RED Loctite when you assemble the parts. The previous owner of mine did not do this and the screws backed out and you can only imagine the carnige that happened. I ended up having to totally rebuild due to all the metal contamination.

  • fog527

Posted April 08, 2004 - 05:06 AM


If you don't already know you need to remove the gear off your old basket..the directions they give are pretty simple
I've drilled out the rievts and I've ground the heads off and punched them out both ways work..when you install the center gear in new basket place the GEAR in the freezer 1/2 hr or so..I put the basket on a cookie sheet and slap it in the oven for five mins. at 300 deg....spray a little wd-40 on the both of 'em and the gear drops right in...a little help from a rubber faced mallet is the most you'll need...the loctite they give you with the basket...make sure you use it or like the man said ..carnage....I'm tellin' ya you will notice the differenc with these in there....I notice you didn't buy an inner hub .....pricey aint can buy alot of stock ones for what they get ya for one...the thing that alot of guys do is drill extra holes in the inner hub to increase oil flow not so many you weaken it but just a few..good luck...

Related Content


Snake pit oct 30th by The Anvil

Dirt Bike   Dirt Bike Regional Discussion   California
  • Hot  293 replies

Megabomb Fitment by 288yz450

Dirt Bike   Make / Model Specific   Yamaha   YZ 400/426/450
  • 1 reply

Should I buy this bike? help....... by Numsa Hul

Dirt Bike   General Dirt Bike Forums   What bike should I buy?
  • * * * * *
  • 10 replies

The "going back to the other darkside" adventure... by Monk

Dirt Bike   Make / Model Specific   KTM   250/350/450/505 SX-F & XC-F (4-Strokes)
  • Hot  113 replies
WR Camshaft Swap Info - last post by jamesm113

WR Camshaft Swap Info

  • 0 replies

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.