WR hydraulic rear brake light switch...


2 replies to this topic
  • Gadsen

Posted April 06, 2004 - 06:03 PM

#1

OK guys, have a 2001 WR 426F and will be ordering a brake light switch for the rear master cylinder. My question is, what is the thread pitch on the banjo bolt, my choice is 1 of 2, I want to get the correct one. Thanks! :)

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • wrooster

Posted April 06, 2004 - 06:43 PM

#2

you need the coarser thread one, "10mm x 1.25mm" i think it is referred to as.
more info in the links here:
http://www.thumperta...4106#Post964106

jim aka the wrooster
'01 wr250f

  • Gadsen

Posted April 07, 2004 - 06:07 PM

#3

you need the coarser thread one, "10mm x 1.25mm" i think it is referred to as.


Jim, thats what I was looking for. Yes, I knew it was either 10X1.0 or 10X1.25. I will order it tomorrow. I just ordered an LED rear type 1157 bulb today. This should keep the brake light bright without sapping too much current from the headlamp! Thanks again Jim :)




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.