Jump to content

  • Follow us:

  • Facebook
  • YouTube
  • Twitter
  • Google+
  • Instagram
  • RSS Feed
  • Google+

- - - - -

Replacing crank bearings, locking tabs

  • Please sign in to reply

2 replies to this topic
  • jflo13

    TT Newbie

6 posts

Posted August 04, 2016 - 04:33 PM

I'm doing this 2006 wr 450, replacing all bearing after lubrication failure. I see that the main bearings have a special screw that's been indented for security. How do I go about removing this? I know the tabs will be chewed out if I just go for it and the screw drive could potentially strip...it looks too thick of an edge to bend back up? Are the screws and tabs one time use parts? Any insight appreciated! Thanks ImageUploadedByThumper Talk1470357125.586815.jpg

  • knuckleduster271

    TT Bronze Member

215 posts
Location: Ohio

Posted August 04, 2016 - 05:03 PM

I just put a torx socket on a 3/8 impact and go to town-

  • ttreewalkerr

    TT Bronze Member

138 posts

Posted August 05, 2016 - 04:06 PM

For some reason your question is not visible.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.