'00 YZ426 Clutch Rod

No replies to this topic
  • mike_dean

Posted June 08, 2016 - 12:00 PM


The '00 yz426 clutch rod is not avail. anymore, mine was mushroomed over and worn at the lever end so I was using up all my cable adjustment and the lever at the case was binding. I found that if I installed a YZ250 valve adjustment shim in the pressure plate lifter I could fine tune the worn end perfectly, I ended up using a 1.50 shim.IMG_6278.JPG IMG_6277.JPG

Related Content


Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.