XRL jetting


No replies to this topic
  • uw153

Posted March 11, 2004 - 03:41 AM

#1

Hey all, I thought I'd pick your brains a bit. I have an '01 XRL and have it setup with the following. 165 main, 52 pilot, K&N air filter, FMF "Q", the Dynojet needle in third position, and the vacuum piston drilled. Here's my question, I am adding a FMF Power bomb header this year, can anyone give me some thought's as to if I should change anything?? I thought about going to a 55 pilot and I have had one in before but it seemed to run a little rich then so I went back to the 52. I am in Iowa around 200ft above sea level if that helps.





Related Content

Wiki
Want to add a kickstart to your XR650L?  Here's how - last post by clc3251

Want to add a kickstart to your XR650L? Here's how


Articles
  • 0 replies
Forums
Photo

Engine Loping/Sputtering by tcaldwell


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 2 replies
Forums
Photo

2015 XR650L Squeaking noise by Crayjay


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • 3 replies
Forums
Photo

Post Apocalypse, ThumperTalk style! by Justin Pearson


Dirt Bike   General Dirt Bike Forums   General Dirt Bike Discussion
  • Hot  35 replies
Forums
Photo

XR650L super moto wheels by greggkklee


Dirt Bike   Make / Model Specific   Honda   XR600/650
  • Hot  28 replies
 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.