Waterpump bearing and shaft freeplay


2 replies to this topic
  • danpat1508

Posted December 18, 2015 - 12:50 AM

#1

Hi,iknow this topic has been done to death but I haven't been able to find the answers im looking for.
Just replaced the seals in the waterpump and was wondering when installing the bearing if it sits flush where it sits? Or just below the lip of the case surface?
Also wondering if when the seals, bearings, shaft and impeller are back in place. Should there be any in and out movement?
Thanks again.

Visit the ThumperTalk Store for the lowest prices on motorcycle / ATV parts and accessories - Guaranteed
  • GuyGraham

Posted December 18, 2015 - 08:56 AM

#2

just done mine

bearings sits flush with c/case cover (or as near as)

yes there is in & out float of the shaft (about 2-3mm)



  • danpat1508

Posted December 18, 2015 - 05:55 PM

#3

Thanks for that mate. Just wanted to double check.




 
x

Join Our Community!

Even if you don't want to post, registered members get access to tools that make finding & following the good stuff easier.

If you enjoyed reading about "" here in the ThumperTalk archive, you'll LOVE our community. Come join ThumperTalk today!

The views and opinions expressed on this page are strictly those of the author, and have not been reviewed or approved by ThumperTalk.